Atomium (Suprotec) MotoTec 2

Tribotechnical compound "MOTOTEC 2" restores worn parts and protects metal surfaces in friction assemblies from wear. Application of the compound reduces the friction losses, increases power, and reduces fuel consumption, noise and vibration.

The compound protects all the friction surfaces both in cylinder-piston group and crank mechanism.

Tribotechnical compound "MOTOTEC 2"

The compound is designed to restore the performance and protect against wear the two-stroke engines of mopeds, all-terrain vehicles (quad bikes), outboard motors, chainsaws and other equipment, including engines with separate lubrication system.

100 ml

For treatment of the two-stroke engines

Tribotechnical compound "MOTOTEC 2"
Certified in accordance with the international quality standard
ISO 9001-2001

Non-toxic.
Storage temperature: from -20 ᵒС to +70 ᵒС
Shelf life: 5 years

Safety precautions and first aid:

It is not expected any health hazard when used under normal conditions.

In case of a contact with skin, wash out with warm water, and then wash again with soap.

In case of contact with eyes, wash out eyes with large amount of water.

In case of swallowing, consult a doctor.

Notes

Shelf life: 5 years. Manufacturing date is indicated on the can.

It is not recommended to apply the compound at existence of mechanical breakages of parts and assemblies.

The greenish sediment on the bottom of the can is the main working element of compound «MOTOTEC 2» - these are microparticles of minerals. It is strictly important to stir the contents of the can thoroughly before pouring it in the engine oil system (sediment color, depending on the release batch, can vary from light green to dark gray and black).

Compound «MOTOTEC 2» is compatible with all types of fuel and oil.

Overdose of compound by 2-2.5 times is not dangerous for the engine and does not disturb its work.

Compound «MOTOTEC 2» does not affect the characteristics and status of parts made of composite materials and rubber.

Instructions for application

Tribotechnical compound "MOTOTEC 2" is added to the working oil of the engine according to the following procedure:

Warm up the engine to operating temperature.

Stop the engine.

Stir the contents of the can thoroughly until natural sediments (active components) are totally dissolved.

Apply the compound through the regular oil filling neck.

If the lubrication system is separate system – apply only the half of the can through the regular oil filling neck.

If the lubrication system is common system – apply the compound at the rate of 5 ml per 1 liter of oil through the regular oil filling neck.

Start the engine and let it run for 10-15 minutes immediately after the procedure.

Complete engine treatment is carried out as follows: